...

POLYMERIZER M-18

080402

Ajouter à ma liste

Made completely of stainless steel. Polymerizes 18 flasks with clamp 030390

The M-18 polymerizer is equipped with a processor to change temperature according to a pre-set programme.

On the M-18 the operator (user) can select the following:

a) A delayed start time set in hours and minutes from 0.00 to 99 hours 59 minutes. This means the programme can be pre-set to start at a specific time. The delay works every time the programme is initiated.

b) The duration of each temperature increase gradient in hours and minutes from 0.00 to 99 hours 59 minutes.

c) The desired holding time in hours and minutes from 0.00 to 99 hours 59 minutes at each plateau.

END OF TREATMENT WARNING BUZZER

– When the programme completes treatment or A4 a modulated warning buzzer is set off for one minute. When the alarm buzzer sounds, press any key to acknowledge the alarm and continue the programme.

– If the power fails the regulator stores all its data, and when power returns it continues from the same point in the programme.

– Programmes and parameters are stored indefinitely when power to the regulator is cut off.

Standard UL 61010C-1

TECHNICAL CHARACTERISTICS. OUTSIDE DIMENSIONS:

Height (with handle): 510 mm

Width (with drop): 420 mm

Length: 500 mm

Weight: 20 kg

Supply voltage: 230 V, 50/60 Hz

Rated power: 3000 W

INSIDE DIMENSIONS:

Height: 350 mm

Widht: 320 mm

Lengh: 400 mm

Télécharger

Related products(30)